Thank you for your reply. I will do as you said.
I have followed your instructions and successfully run multithreading on multicore. However, I need to run a great number of multithreaded, which is more than the number of 5 subcores, therefore, I would like to use multithreading on one core as well.
Could you give me some advice?
Thank you for the reply. I would like to use multithreading on multicore.
About the tutorial in the first link, it was about writing a program using Arduino IDE to blink the 4 LEDs on the board itself, it was just to verify the setup was correct.
I am trying to write a program using multithreading on the Arduino IDE.
I have successfully run the example in the following tutorial:
And I have also installed the Spresense SDK by following this instruction, since I read that this SDK provides Multitasking RTOS.
Can you give me advice on how to apply the Spresense SDK in Arduino IDE to use Multitasking RTOS.
If Arduino IDE is not usable, is there any instruction or example on using Spresense SDK for Multitasking RTOS?
And one more thing, when I build an application using "Application build" or "Build and Flash" it seems to build the whole SDK every time I make changes to the code, and it takes a long time to rebuild, is there any way to improve this?
Thank you very much for your help.